Страница 1 из 1

RST MODE (Restart Mode)

Добавлено: 21 янв 2016, 14:36
ashoori
In CONFIGURE menu of AANDC, the value of RST MODE (Restart Mode) is 0, which is the “Default”:
When we are in this mode, “Power Failure” Message is sent but “Last Transaction Status Data” is not sent. I set the value of RST MODE (Restart Mode) to 3 (Auto Recovery) and “Last Transaction Status Data” was sent but in this mode “Power Failure” Message was not sent.
RST-MODE.gif
What changes should I make in Configuration or which parameters should I set so that I can both receive “Power Failure” Message and “Last Transaction Status Data”?

Re: RST MODE (Restart Mode)

Добавлено: 20 фев 2016, 13:10
mss230479
Please set 2 Native Mode (NCR).