CMDV4 ошибка 2\5
Добавлено: 01 дек 2010, 17:22
День добрый господа ошибка 2\5 на диспенсере, при проведении 2 теста не открывается шатер. При тестах в СОП-е молчит шатер. В маунале указано расплывчато. Вопрос в чем там дело ?
Выдержка из мануала:
It was not possible to bring the
main motor (DCM 1) up to
minimum speed after a short start-
up period. Select '1' (Reset) on the
function button.
If the motor tries to start, but there
is a loud running noise: check the
cash paths of the CMD-V4 for a
massive note jam. Check the inlet
to the reject/retract cassette for
jammed notes.
Set the CMD-V4 in the safe to
cash-out position (safety switch
closed) and select test function 2
(mechanical test) on the function
button after starting up the CMD-
V4: check the running noise and
transport function of the main
motor.
If the main motor does not rotate
or if this test function once again
ends with status display '25', the
output transport or the controller
must be replaced, otherwise the
CMD-V4 cannot be operated.
main motor (DCM 1) up to
minimum speed after a short start-
up period. Select '1' (Reset) on the
function button.
If the motor tries to start, but there
is a loud running noise: check the
cash paths of the CMD-V4 for a
massive note jam. Check the inlet
to the reject/retract cassette for
jammed notes.
Set the CMD-V4 in the safe to
cash-out position (safety switch
closed) and select test function 2
(mechanical test) on the function
button after starting up the CMD-
V4: check the running noise and
transport function of the main
motor.
If the main motor does not rotate
or if this test function once again
ends with status display '25', the
output transport or the controller
must be replaced, otherwise the
CMD-V4 cannot be operated.